
############################################
DXLink Fiber Transmitter Firmware Release Notes
############################################

| Firmware Version:   v1.2.12
| Firmware KIT File:  SW1010_36x_AVB_FW_v1_2_12.kit
| Release Date:       5 January 2015

=========== ========== ============================================
FG#         Name              Description
=========== ========== ============================================
FG1010-360  DXF-TX-SMD  DXLink Transmitter, HDMI, SM Fiber, Duplex
FG1010-361  DXF-TX-SMS  DXLink Transmitter, HDMI, SM Fiber, Simplex
FG1010-362  DXF-TX-MMD  DXLink Transmitter, HDMI, MM Fiber, Duplex
FG1010-363  DXF-TX-MMS  DXLink Transmitter, HDMI, MM Fiber, Simplex
=========== ========== ============================================


!!IMPORTANT: DIP 4 IS NOW USED ON DUPLEX DEVICES.  PLEASE READ ABOUT
  CHANGES TO DIP SWITCH 4 IN NOTABLE POINTS SECTION BELOW!!

Changes in the Release
----------------------

Fixed an issue where a Tx without connection to an AMX master, would
  require a power cycle after a period of approximately 3 months. 


Known Issues
------------

- Analog processing can fail for certain CVR1960H and 576i50 formats. 
- Composite video can display a thin white stripe at right edge of image.
- Local Output can flicker occassionally with 1600x1200 format.


Prerequisites
-------------

- DXF-RX-xxD v1.2.1 (or later) to support standalone behavior.

- Enova DGX enclosures will need Enova DGX 8/16/32 FW V2.0.0.x (or later)
  And correct Master FW:
	- SW1058_Master_v4_2_394.KIT (NI-Series)
	  Shows in Online Tree as "NI Master"
	 
	- SW1060_Master_v1_2_312.KIT (NX-Series)
	  Shows in Online Tree as "DGX Master"

- NetLinx Studio v4.0 
  
- DGX Configuration Software v1.0.6 or later


Notable Points
--------------
- On duplex devices, if DIP switch 4 is set ON, the device
  will be put into unidirectional mode.  This will make the
  duplex device act similarly to a simplex device.
  Ethernet and control over the fiber link will be disabled.
  See the instruction manual for details.

- Please read Known Issues section (above) for important reccomendation
  for setting DIP switch 3.

- Please read the documentation in regard to the DIP
  switches located on the bottom of the Tx/Rx modules
  before attempting to connect to the network.

- The TX module uses these solid color screen indications:

  RED
    Indicates an HDCP authentication failure with
    the HDMI sink (monitor or other device) connected to the
    local output.



Programming Information
-----------------------

No special notes for programming the firmware.
