Release Notes

Product: DXFP-RX-4K60
Description: DXLink 4K60 HDMI Fiber Receiver Module

FG#: FG1010-565-01 
     FG1010-565-02 (TAA)

File Name: SW1010-565-0X_DXFP-RX-4K60_1_7_1
Release Date:     5/5/2021
Firmware Version: v1.7.1


1. Prerequisites
2. Features added in this release
3. Fixes in this release:
4. Known Issues
5. Programming Information
6. Notable Points


----------------------------------------------------------
1. Prerequisites
----------------------------------------------------------

- Directly connected DXFP-TX-4K60 v1.7.1 (or later)
- Enova DGX 800/1600/3200/6400 Switcher FW v3.8.13 (or later)
- Enova DGX 100 Series Controller FW v1.8.90 (or later)
- NetLinx Studio v4.3.1519 (or later)

----------------------------------------------------------
2. Features added in this release:
----------------------------------------------------------
 - Initial Release

----------------------------------------------------------
3. Fixes in this release: 
----------------------------------------------------------
 - Fixed issue where sending RXCLR would require reboot to send other commands
 - Fixed problem where DVI HDCP1.4 signal through TX-RX pair results in snow after 
   hotplug of HDMI cable
 - Improved ID button functionality to match expected results as outlined in manual
 - Improved how TX WebGUI pages get refreshed when connection mode changes
 - Fixed "No Video" issue for RX after hotplug or power cycle when connected to DGX or DVX

----------------------------------------------------------
4. Known Issues
----------------------------------------------------------
 - When scaler is set to BYPASS, some image settings on the web interface are invalid
 - When connectoin mode is NDP, the Controller URL cannot be set as IP on web, but only MAC addrass. for TCP/UDP mode vice-versa.

----------------------------------------------------------
5. Programming Information
----------------------------------------------------------
- These devices can be updated using a VNM (Virtual Netlinx Controller)
  but the update will go much faster if you can connect to a physical
  Netlinx controller.  VNM update could take up to 2 hours but
  using a physical controller should take less than an hour.  

----------------------------------------------------------
6. Notable Points
----------------------------------------------------------
 - PLEASE READ the Quick Start Guide in regard to the DIP switches located on the 
   DXLink 4K60 HDMI Fiber Receiver Module before attempting to connect to the network.

- These units have a web interface that is accessible by entering
  the URL of the device into a web browser.  This may indicate there
  is a certificate error, but you can select the Advanced option at 
  the bottom and proceed to the page.  A new certificate can be loaded
  via the web interface.

 - This web interface is only available when connected to a DXLink 4K60 Fiber Transmitter.
   It is disabled when connected to other devices or a switcher.

 - This device has a default static IP: 192.168.1.2 when it isn't assigned a dynamic IP 
   by DHCP server or auto-setup porcess.
   