############################################
DXLink Fiber Receiver Firmware Release Notes
############################################

| Firmware Version:   1.0.1
| Firmware KIT File:  SW1010_56x_AVB_KIT_DXLF_RX_v1_0_1.kit
| Release Date:       19 February 2014

=========== ================= ========================================
FG#         Name              Description
=========== ================= ========================================
FG1010-560  DXLF-HDMIRX-SM-D  DXLink Receiver, HDMI, SM Fiber, Duplex
FG1010-562  DXLF-HDMIRX-MM-D  DXLink Receiver, HDMI, MM Fiber, Duplex
=========== ================= ========================================


Known Issues
------------

Any known issues with the release will be noted here.



Prerequisites
-------------

- Enova DGX enclosures will need Enova DGX 8/16/32 Master FW v4.2.379
  and Enova DGX 8/16/32 FW V1.6.1.1 (or later)

- NetLinx Studio V3.3 - Build 525 or later



Notable Points
--------------

- Please read the documentation in regard to the DIP
  switches located on the bottom of the Tx/Rx modules
  before attempting to connect to the network.

- After a FACTORYAV (ICSP) or RESET FACTORY (telnet) command,
  a reboot of the RX is required.

- The RX module uses these solid color screen indications:

  ORANGE
    Indicates an HDCP authentication failure with
    the connected HDMI sink (monitor or other device).

- If using a hostname in the USB_HID_ROUTE command,
  the hostname length is limited to 50 characters.



Programming Information
-----------------------

No special notes for programming the firmware.

