The BLU-800 has all the features of the BLU-80 with 4 times the DSP power and the addition of BSS Audio BLU link technology.
The BLU-800 has all the features of the BLU-80 with 4 times the DSP power and the addition of BSS Audio BLU link technology.
BLU link is a 256 channel(48kHz), redundant, low latency, digital audio transport. See the BLU devices technical specifications here. The additional DSP power combined with BLU link increases the Soundweb London BLU-800 matrix capability up to 128x128 in a single device.
The BLU-800 can accept 4 input or output cards, each card being either 4 analogue or digital inputs or 4 analogue or digital outputs. In addition, the BLU-800 also accepts AEC cards. This means that a BLU-800 is easily configured at base or in the field to provide a wide variation of I/O configurations.
16 Inputs 0 Outputs
12 Inputs 4 Outputs
8 Inputs 8 Outputs
4 Inputs 12 Outputs
0 Inputs 16 Outputs
Name: The name of this item
Class Name: The type of this device
Device ID: The ID number of this device
CM1 Meters: On or Off
CobraNet Latency: Sets the CobraNet latency - 1 1/3, 2 2/3 or 5 1/3 mS
BLU link sync: The sync source for the BLU link digital audio bus. Default, Sync to BLU link or sync to BNC
Sample Rate Pulldown: Sample rate pulldown frequency when an external sync source is being used
Sample Rate: Offers changing the sample rate from 48kHz to 96kHz and vice-versa
Acknowledge (ACK): Set to 'yes' to inform the London device that is should expect acknowledgement of the messages being sent.
Baud Rate: Drop-down selection for the Baud Rate
Data Bits: The number of bits for data
Parity: The parity
Stop Bits: The number of stop bits
Dynamic Meters: The number of Dynamic Meters to use in this device. Hover the cursor over a wire in the design while online and a Dynamic Meter displays the signal level.
Logic Change Block: If enabled, only Logic Sources and Ends will be written to the change block. Only enable if there are performance issues with logic.
Logic Subscription: If enabled, only Logic Sources and Ends will be subscribed to. Only enable if there are issues with logic.
Recall Presets on Startup: When enabled, presets assigned to control ports will be recalled when the device is powered on.
Control Port Subscribe: When enabled, force control ports to subscribe to controlled parameters.