The PIP-USP3 is a DSP-based IQ-PIP™ module that integrates into a 100 MB Ethernet network via HiQNet™ protocol. An extremely versatile speaker-processing unit that mounts right in your Crown amplifier, this compact module greatly reduces the costs of typical audio systems while eliminating the rack space needed for signal processing. The PIP-USP3 offers up to thirty-two filters per channel as well as load supervision that continuously monitors the load impedance using the signal source as the test signal. It also includes compressors, limiters, error reporting, ten internal presets, up to two seconds of delay per channel, and noise and sine-wave generators. Line voltage monitoring is also available when the module is installed in Crown CTs series amplifiers.
Listen Bus amplifier output monitor
24-bit conversion with 32-bit, floating point DSP processing
64 assignable filters with 9 different filter types including all-pass filters
Over two seconds of delay available per channel
Input compressors and output limiters for each channel
Dual, uncorrelated noise generators for noise masking
Sine-wave generator
Load supervision
Full error reporting
Firmware upgrades via the network
Ten user selectable presets
Reliable FLASH memory backup of all parameters