The 1 Click Setup is setting up the Frequency Management for the entire wireless system with a single click. It calculates compatible (intermodulation free) frequencies in realtime for the entire wireless system (for all bands) and is performed automatically.
IMPORTANT: It is recommended to perform a 1 Click Setup with an online wireless system at the location where the wireless system is used.
To perform a 1 Click Setup following preparations must be done.
Switch OFF all transmitters of DMS700 (DHT/DPT700) and WMS4x00 (HT/PT4x00)
Switch ON all other wireless devices (at their desired RF frequency) which may produce RF signals
There are 2 possible options to start the 1 Click Setup
1 Click Setup Standard
calculates intermodulation free frequencies automatically
no further user settings needed
straight forward frequency management for small wireless systems
--> Start by pressing the 'START' button
offers advanced settings for expert frequency management
exclude frequency ranges, TV channels, or single frequencies
load environment scan for offline calculation
set scan threshold
select devices to be included at 1 Click Setup
--> Start by pressing the 'Start with Expert Settings'
Following steps are preformed (at 1 Click Setup Standard and 1 Click Setup Expert):
Environment Scan (optional): First an Environment Scan is performed to scan the RF Environment (is done only if there are online Scan Devices).
Check: 1 Click Setup will check if frequencies are compatible (intermodulation free). Only NOT compatible frequencies are changed by 1 Click Setup
Calculation: Compatible (intermodulation free) frequencies are calculated for the NOT compatible wireless system which have been identiefied by Check Step.
Choose Devices (optional): If not enough frequencies were found the user must specify the AKG Devices which should use the found frequencies.
Result: The last step shows the result of 1 Click Setup.
Figure: 1 Click Setup - Start Page